Liberty Forstner Bit & Template To Install 35mm European Concealed Hinge AN0192C-G-Q

Professional Tip: It is recommended that you double check all of your required measurements and then bore a test hole in a piece of scrap to confirm these measurements before starting your project. 1. Mark center point of top and bottom hinge location on door back at equal distance from top and bottom of door edges. Any center hinges should be equal distance from hinges on either side.
2. Position ALIGNright template against hinge side of door at locations marked. Mark center point (template position “C”) to be drilled for 35mm hole. Place center point of 35mm drill bit on marked position and drill slowly to 1/2″ depth. Do not drill completely through door.
3. Position hinge cup in 35mm hole and verify pilot hole positions Most major brands use pilot holes “A” or “B”. For others, make changes where necessary before drilling 1/16″ pilot holes. L-AN0192C-G-Q